Halt – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 137
120
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
erase [cf:|flash:|nvram:|startup-config|usb1:]
Parameters
erase [cf:|flash:|nvram:|startup-config|usb1:]
Example
rfs7000-37FABE#erase startup-config
Erase startup-config? (y/n): n
rfs7000-37FABE#
halt
Stops (halts) a device (access point, wireless controller, or service platform). Once halted, the
system must be restarted manually.
This command stops the device immediately. No indications or notifications are provided while the
device shuts down.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
halt {on <DEVICE-NAME>}
Parameters
cf:
Erases everything in the device's cf: file
flash:
Erases everything in the device’s flash: file
nvram:
Erases everything in the device’s nvram: file
startup-config
Erases the device’s startup configuration file. The startup configuration file is used to configure the device
when it reboots.
usb1:
Erases everything in the device's usb1: file