Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 105
88
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
clear gre stats {on <DEVICE-NAME>}
clear ip dhcp bindings [<IP>|all] {on <DEVICE-NAME>}
clear ip ospf process {on <DEVICE-NAME>}
clear l2tpv3-stats tunnel <L2TPV3-TUNNEL-NAME> {on <DEVICE-NAME>|session
<SESSION-
NAME> {on <DEVICE-NAME>}}
flows
Clears established firewall sessions
on <DEVICE-NAME>
The following keywords are common to the DHCP, DOS, and flows parameters:
•
on <DEVICE-NAME> – Optional. Clears DHCP snoop table entries, denial of service statistics, or the
established firewall sessions on a specified device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
gre stats
Clears GRE tunnel statistics
on <DEVICE-NAME>
Optional. GRE tunnel statistics on a specified device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
ip
Clears a Dynamic Host Configuration Protocol (DHCP) server’s IP address bindings entries
dhcp bindings
Clears DHCP server’s connections and address binding entries
<IP>
Clears specific address binding entries. Specify the IP address to clear binding entries.
all
Clears all address binding entries
on <DEVICE-NAME>
Optional. Clears a specified address binding or all address bindings on a specified device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
ip ospf process
Clears already enabled open shortest path first (OSPF) process and restarts the process
on <DEVICE-NAME>
Optional. Clears OSPF process on a specified device
OSPF is a link-state interior gateway protocol (IGP). OSPF routes IP packets within a single routing domain
(autonomous system), like an enterprise LAN. OSPF gathers link state information from neighbor routers
and constructs a network topology. The topology determines the routing table presented to the Internet
layer which makes routing decisions based solely on the destination IP address found in IP packets.
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
l2tpv3-stats
Clears L2TPv3 tunnel session statistics
tunnel
<L2TPV3-TUNNEL-NAME>
Clears all sessions associated with a specified L2TPv3 tunnel
•
<L2TPV3-TUNNEL-NAME> – Specify the L2TPv3 tunnel name.
{on <DEVICE-NAME>|
session <SESSION-
NAME> {on <DEVICE-NAME>}}
Use the following optional parameters to specify a session or device.
•
on <DEVICE-NAME> – Optional. Clears all sessions associated with the specified L2TPv3 tunnel
running on a specified device
•
DEVICE-NAME> – Specify the name of the AP, wireless controller, or
service platform.
•
session <SESSION-NAME> – Optional. Clears a specified L2TPv3 tunnel session. Specify the
session name.
•
on <DEVICE-NAME> – Optional. Specifies the device running the L2TPv3 tunnel session
•
DEVICE-NAME> – Specify the name of the AP, wireless controller, or
service platform.
If no optional parameters are specified, the system clears all L2TPv3 tunnel session statistics.