Wep64 – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 377
Brocade Mobility RFS Controller CLI Reference Guide
361
53-1003098-01
4
rfs7000-37FABE(config-wlan-test)#
wep64
Configures WEP64 parameters
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
wep64 [key|keys-from-passkey|transmit-key]
wep64 key <1-4> [ascii|hex] [0 <WORD>|2 <WORD>|<WORD>]
wep64 keys-from-passkey <WORD>
wep64 transmit-key <1-4>
Parameters
wep64 key <1-4> [ascii|hex] [0 <WORD>|2 <WORD>|<WORD>]
wep64 keys-from-passkey <WORD>
wep64 transmit-key <1-4>
wep64
Configures WEP64 parameters
The parameters are: key, key-from-passkey, and transmit-key.
key <1-4>]
Configures pre-shared hex keys
•
<1-4> – Configures a maximum of four key indexes. Select a key index from 1 - 4.
ascii
[0 <WORD>|
2 <WORD>|<WORD>]
Sets keys as ASCII characters (5 characters for WEP64, 13 for WEP128)
•
0 <WORD> – Configures a clear text key
•
2 <WORD> – Configures an encrypted key
•
<WORD> – Configures key (10 hex or 5 ASCII characters for WEP64, 26 hex or 13 ASCII characters for
WEP128).
hex
[0 <WORD>|
2 <WORD>|<WORD>]
Sets keys as hexadecimal characters (10 characters for WEP64, 26 for WEP128)
•
0 <WORD> – Configures a clear text key
•
2 <WORD> – Configures an encrypted key
•
<WORD> – Configures the key (10 hex or 5 ASCII characters for WEP64, 26 hex or 13 ASCII characters
for WEP128)
keys-from-passkey
<WORD>
Specifies a passphrase from which keys are derived
•
<WORD> – Specify a passphrase from 4 - 32 characters.
transmit-key <1-4>
Configures the key index used for transmission from an AP to a wireless client or service platform
•
<1-4> – Specify a key index from 1 - 4.