Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 68)

50 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
2
Parameters
None
Example
rfs7000-37FABE#disable
rfs7000-37FABE>
enable
User Exec Commands
Turns on (enables) the privileged mode command set. This command does not do anything in the
Privilege Executable mode.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
enable
Parameters
None
Example
rfs7000-37FABE>enable
rfs7000-37FABE#
join-cluster
User Exec Commands
Adds a device (access point, wireless controller, or service platform), as a member, to an existing
cluster of devices. Assign a static IP address to the device before adding to a cluster.
Supported in the following platforms:
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
join-cluster <IP> user <USERNAME> password <WORD> {level|mode}
join-cluster <IP> user <USERNAME> password <WORD> {level [1|2]|mode
[active|standby]}
Parameters