Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 650)

Brocade Mobility RFS Controller CLI Reference Guide 637
53-1003098-01
7
email-notification host <SMTP-SERVER-IP> sender <SENDER-EMAIL>
{username <SMTP-USERNAME>} [password [2 <WORD>|<WORD>]] {port
<1-65535>}
Parameters
email-notification recipient <RECIPIENT-EMAIL>
email-notification host <SMTP-SERVER-IP> sender <SENDER-EMAIL> {port
<1-65535>}{username <SMTP-USERNAME>} [password [2 <WORD>|<WORD>]]
email-notification host <SMTP-SERVER-IP> sender <SENDER-EMAIL>
{username <SMTP-USERNAME>} [password [2 <WORD>|<WORD>] {port <1-65535>}
Example
rfs7000-37FABE(config-profile-default-rfs7000)#email-notification recipient
[email protected]
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
dscp-mapping 20 priority 7
no autoinstall configuration
no autoinstall firmware
.............................................................
interface ge4
ip dhcp trust
recipient
<RECIPIENT-EMAIL> Defines the recipient’s e-mail address. A maximum of 6 (six) e-mail addresses can the configured.
•
<RECIPIENT-EMAIL> – Specify the recipient’s e-mail address (should not exceed 64 characters in
length).
host
<SMTP-SERVER-IP> Configures the host SMTP server
•
<SMTP-SERVER-IP> – Specify the SMTP server’s IP address.
sender
<SENDER-EMAIL> Defines the sender’s e-mail address
•
<SENDER-EMAIL> – Specify the sender’s e-mail address (should not exceed 64 characters in length).
port <1-65535> Optional. Configures the SMTP server port
•
<1-65535> – Specify the port from 1 - 65535.
username
<SMTP-USERNAME> Optional. Configures the SMTP username
•
<SMTP-USERNAME> – Specify the SMTP username (should not exceed 64 characters in length).
password
[2 <WORD>|<WORD>] Configures the SMTP server password
•
2 <WORD> – Configures an encrypted password
•
<WORD> – Specify the password (should not exceed 127 characters in length).
host
<SMTP-SERVER-IP> Configures the host SMTP server
•
<SMTP-SERVER-IP> – Specify the IP address of the SMTP server.
sender
<SENDER-EMAIL> Defines sender’s e-mail address
•
<SENDER-EMAIL> – Specify sender’s e-mail address.
username
<SMTP-USERNAME> Optional. Configures the SMTP username
•
<SMTP-USERNAME> – Specify the SMTP username.
password
[2 <WORD>|<WORD>] Configures the SMTP server password
•
2 <WORD> – Configures an encrypted password
•
<WORD> – Specify the password.
port <1-65535> Optional. Configures the SMTP server port
•
<1-65535> – Specify the port from 1 - 65535.