Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 723)

710 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
meshpoint <MESHPOINT-NAME> {bss <1-16>}
Example
rfs7000-37FABE(config-profile-ap71xxTest-if-radio1)#meshpoint test bss 7
rfs7000-37FABE(config-profile-ap71xxTest-if-radio1)#show context
interface radio1
meshpoint test bss 7
rfs7000-37FABE(config-profile-ap71xxTest-radio1)#
Related Commands:
no
interface-config-radio-instance
Negates a command or resets settings to their default. When used in the profile/device > radio
interface configuration mode, the no command disables or resets radio interface settings.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
no <PARAMETER>
Parameters
None
Usage Guidelines:
The no command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
Example
rfs7000-37FABE(config-profile-ap71xxTest-if-radio1)#no ?
aeroscout Use Default Aeroscout Multicast MAC Address
aggregation Configure 802.11n aggregation related parameters
airtime-fairness Disable fair access to medium for clients,
provide access in a round-robin mode
antenna-diversity Use single antenna for non-11n transmit rates
antenna-downtilt Reset ADEPT antenna mode
antenna-gain Reset the antenna gain of this radio to default
antenna-mode Reset the antenna mode (number of transmit and
receive antennas) on the radio to its default
association-list Configure the association list for the radio
beacon Configure beacon parameters
channel Reset the channel of operation of this radio to
default
meshpoint
<MESHPOINT-NAME> Maps a meshpoint to this radio. Specify the meshpoint name.
bss <1-16> Optional. Specifies the radio’s BSS where this meshpoint is mapped
•
<1-16> – Specify the BSS number from 1 - 16.
no Disables meshpoint on the selected radio