Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 700)

Brocade Mobility RFS Controller CLI Reference Guide 687
53-1003098-01
7
aeroscout
interface-config-radio-instance
Enables Aeroscout multicast packet forwarding. This feature is disabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
aeroscout [forward|mac <MAC>]
ldpc Enables support for Low Density Parity Check (LDPC) on the radio interface page 705
lock-rf-mode Retains user configured RF mode settings for the selected radio page 706
max-clients Configures the maximum number of wireless clients allowed to associate with this radio page 707
mesh Configures radio mesh parameters page 708
meshpoint Maps an existing meshpoint to this radio interface page 709
no Negates or resets radio interface settings configures on a profile or a device page 710
non-unicast Configures the handling of non unicast frames on this radio page 713
off-channel-scan Enables selected radio’s off channel scanning parameters page 715
placement Defines selected radio’s deployment location page 716
power Configures the transmit power on this radio page 717
preamble-short Enables the use of short preamble on this radio page 718
probe-response Configures transmission parameters for probe response frames page 719
radio-resource-measu
rement Enables 802.11k radio resource measurement page 720
radio-share-mode Configures the mode of operation, for this radio, as radio-share page 721
rate-selection Sets the rate selection method to standard or opportunistic page 722
remove-override Removes the radio’s channel of operation page 723
rf-mode Configures the radio’s RF mode page 723
rifs Configures Reduced Interframe Spacing (RIFS) parameters on this radio page 725
rts-threshold Configures the Request to Send (RTS) threshold value on this radio page 726
shutdown Terminates or shuts down selected radio interface page 727
sniffer-redirect Captures and redirects packets to an IP address running a packet capture/analysis tool page 727
stbc Configures radio’s Space Time Block Coding (STBC) mode page 729
use Enables use of an association ACL policy and a radio QoS policy by selected radio
interface page 729
wireless-client Configures wireless client parameters on selected radio page 731
wlan Enables a WLAN on selected radio page 732
Commands Description Reference