Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 816)

Brocade Mobility RFS Controller CLI Reference Guide 803
53-1003098-01
7
Example
rfs7000-37FABE(config-profile-testrfs71xx)#service radius
dynamic-authorization additional-port 1700
rfs7000-37FABE(config-profile-testrfs71xx)#
rfs7000-37FABE(config-profile-testrfs71xx)#show context
profile rfs7000 test
service radius dynamic-authorization additional-port 1700
no autoinstall configuration
no autoinstall firmware
crypto ikev1 policy ikev1-default
isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ikev2 policy ikev2-default
isakmp-proposal default encryption aes-256 group 2 hash sha
crypto ipsec transform-set default esp-aes-256 esp-sha-hmac
crypto ikev1 remote-vpn
crypto ikev2 remote-vpn
--More--
rfs7000-37FABE(config-profile-testrfs71xx)#
Related Commands:
Device Config Commands
PROFILES
Use the (config) instance to configure device specific parameters
To navigate to this instance, use the following commands:
<DEVICE>(config)#<DEVICE-TYPE> <MAC>
<DEVICE>(config-device-<MAC>)#?
Device Mode commands:
adopter-auto-provisioning-policy-lookup Use centralized auto-provisioning
policy when adopted by another
controller
adoption-site Set system's adoption site
alias Alias
area Set name of area where the system
is located
arp Address Resolution Protocol (ARP)
auto-learn-staging-config Enable learning network
configuration of the devices that
come for adoption
autogen-uniqueid Autogenerate a unique id
autoinstall Autoinstall settings
bridge Ethernet bridge
captive-portal Captive portal
cdp Cisco Discovery Protocol
channel-list Configure channel list to be
advertised to wireless clients
cluster Cluster configuration
configuration-persistence Enable persistence of configuration
across reloads (startup config
file)
contact Configure the contact
no Removes or resets service command parameters