Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 113)

96 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
3
Copies a file (config,log,txt...etc) from any location to the access point, wireless controller, or
service platform and vice-versa
NOTE
Copying a new config file to an existing running-config file merges it with the existing
running-config file on the wireless controller. Both the existing running-config and the new config file
are applied as the current running-config.
Copying a new config file to a start-up config file replaces the existing start-up config file with the
parameters of the new file. It is better to erase the existing start-up config file and then copy the new
config file to the startup config.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
copy [<SOURCE-FILE>|<SOURCE-URL>] [<DESTINATION-FILE>|<DESTINATION-URL>]
Parameters
copy [<SOURCE-FILE>|<SOURCE-URL>] [<DESTINATION-FILE>|<DESTINATION-URL>]
Example
Transferring file snmpd.log to remote TFTP server.
rfs7000-37FABE#copy flash:/log/snmpd.log
tftp://157.235.208.105:/snmpd.log
Accessing running-config file from remote TFTP server into switch
running-config.
rfs7000-37FABE#copy tftp://157.235.208.105:/running-config running-config
create-cluster
Privileged Exec Mode Commands
Creates a new device cluster, with the specified name, and assigns it an IP address and routing
level
A cluster (or redundancy group) is a set of controllers or service platforms (nodes) uniquely defined
by a profile configuration. Within the cluster, members discover and establish connections to other
members and provide wireless network self-healing support in the event of member's failure.
<SOURCE-FILE> Specify the source file to copy.
<SOURCE-URL> Specify the source file’s location (URL).
<DESTINATION-FILE> Specify the destination file to copy to.
<DESTINATION-URL> Specify the destination file’s location (URL).