Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 430

Advertising

Brocade Mobility RFS Controller CLI Reference Guide

415

53-1003098-01

service pktcap on radio [<1-1024>|all] {(acl-name <ACL>,count

<1-1000000>,direction [any|inbound|outbound],filter

<LINE>,hex,promiscuous,rate <1-100>,snap <1-2048>,

tcpdump,verbose,write [file|url|tzsp <IP/TZSP-HOSTNAME>])}

service pktcap on interface [<INTERFACE>|ge <1-4>|me|port-channel <1-2>|vlan

<1-4094] {(acl-name <ACL>,count <1-1000000>,direction

[any|inbound|outbound],filter <LINE>,hex,rate <1-100>,snap

<1-2048>,tcpdump,verbose,write [file|url|tzsp <IP/TZSP-HOSTNAME>])}

pktcap on radio

Captures data packets on a radio (802.11)

<1-1024>

Captures data packets on a specified radio

•

<1-1024> – specify the radio index from 1 - 1024.

all

Captures data packets on all radios

acl-name <ACL>

Optional. Specify the ACL that matches the ACL name for the 'deny' location

count <1-1000000>

Optional. Sets a specified number of packets to capture

•

<1-1000000> – Specify a value from 1 - 1000000.

direction
[any|inbound|outbound]

Optional. Changes the packet direction with respect to a device. The direction can be set as any, inbound, or
outbound.

filter <LINE>

Optional. Filters packets based on the option selected (must be used as a last option)

•

<LINE> – Define a packet capture filter or select any one of the available options.

hex

Optional. Provides binary output of the captured packets

rate <1-100>

Optional. Specifies the packet capture rate

•

<1-100> – Specify a value from 1 - 100 seconds.

snap <1-2048>

Optional. Captures the data length

•

<1-2048> – Specify a value from 1 - 2048 characters.

tcpdump

Optional. Decodes the TCP dump

verbose

Optional. Provides verbose output

write

Captures packets to a specified file. Provide the file name and location in the following format:
FILE – flash:/path/file
cf:/path/file
usb1:/path/file
usb2:/path/file
nvram:startup-config
URL – tftp://<hostname|IP>[:port]/path/file
ftp://<user>:<passwd>@<hostname|IP>[:port]/path/file
sftp://<user>@<hostname|IP>[:port]>/path/file
tzsp – The TZSP host. Specify the TZSP host’s IP address or hostname.

pktcap on

Captures data packets at a specified interface

•

on – Specify the capture location.

interface [<INTERFACE>|
ge <1-4>|me1|
port-channel <1-2>|
vlan <1-4094>]

Captures packets at a specified interface. The options are:

•

<INTERFACE> – Specify the interface name.

•

ge <1-4> – Selects a GigabitEthernet interface index from 1 - 4

•

me1 – Selects the FastEthernet interface

•

port-channel <1-2> – Selects a port-channel interface index from 1- 2

•

vlan <1-4094> – Selects a VLAN ID from 1 - 4094