Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 269

Advertising
background image

Brocade Mobility RFS Controller CLI Reference Guide

253

53-1003098-01

4

control connection

no Negate a command or set its defaults

reconnect-attempts Maximum number of attempts to reestablish the

tunnel.

reconnect-interval Time interval between the successive attempts to

reestablish the l2tpv3 tunnel

retry-attempts Configure the maximum number of retransmissions for

signaling message

retry-interval Time interval (in seconds) before the initiating a

retransmission of any l2tpv3 signaling message

rx-window-size Number of signaling messages that can be received

without sending the acknowledgement

tx-window-size Number of signaling messages that can be sent

without receiving the acknowledgement

clrscr Clears the display screen

commit Commit all changes made in this session

end End current mode and change to EXEC mode

exit End current mode and down to previous mode

help Description of the interactive help system

revert Revert changes

service Service Commands

show Show running system information

write Write running configuration to memory or terminal

rfs7000-37FABE(config-l2tpv3-policy-L2TPV3Policy1)#

Related Commands:

NOTE

For more information on the L2TPv3 tunnel configuration mode and commands, see

Chapter 23,

L2TPV3-POLICY

.

mac

Global Configuration Commands

Configures MAC access control lists

Access lists define access permissions to the network using a set of rules. Each rule specifies an
action taken when a packet matches the rule. If the action is deny, the packet is dropped. If the
action is permit, the packet is allowed.

Supported in the following platforms:

Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point

Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000

Service Platforms — Brocade Mobility RFS9510

no

Removes an existing L2TPv3 tunnel policy

mint-policy

Configures the global MiNT policy

Advertising