Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 489
Brocade Mobility RFS Controller CLI Reference Guide
475
53-1003098-01
6
show ip ospf {border-router|interface|neighbor|route|on|state} {on
<DEVICE-NAME>}
Example
rfs7000-37FABE(config)#show ip arp on rfs7000-37FABE
-----------------------------------------------------------------------------
---
IP MAC INTERFACE TYPE
-----------------------------------------------------------------------------
---
172.16.10.12 5C-D9-98-4C-04-51 vlan1 dynamic
172.16.10.4 00-15-70-38-06-49 vlan1 dynamic
-----------------------------------------------------------------------------
---
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show ip interface brief on rfs7000-37FABE
-----------------------------------------------------------------------------
--
INTERFACE IP-ADDRESS/MASK TYPE STATUS PROTOCOL
-----------------------------------------------------------------------------
--
me1 192.168.0.1/24 primary UP down
vlan1 172.16.10.1/24 primary UP up
-----------------------------------------------------------------------------
--
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show ip route test on rfs7000-37FABE
+-------------------------+--------------------+------------+-------------
| DESTINATION | GATEWAY | FLAGS | INTERFACE |
+-------------------------+--------------------+------------+-------------
| 157.235.208.0/24 | direct | C | vlan4 |
pppoe1
Displays Point-to-point Protocol over Ethernet (PPPoE) interface route table details
wwan1
Displays Wireless WAN route table details
on <DEVICE-NAME>
The following keywords are recursive and common to all of the above parameters:
•
on <DEVICE-NAME> – Displays route table details, based on the parameters passed, on a specified
device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
ip ospf
Displays overall OSPF information
border-router
Optional. Displays details of all the border routers connected
interface
{on| vlan <1-4094>}
{on <DEVICE-NAME>}
Optional. Displays details of all the interfaces with OSPF enabled
•
on <DEVICE-NAME> – Optional. Displays specified device details
•
vlan <1-4094> – Displays VLAN interface details
•
<DEVICE-NAME> – Specify the name of the AP or wireless controller.
neighbor
Optional. Displays an OSPF neighbors list
route
Optional. Displays OFPS routes information
state
Optional. Displays an OSPF process state
on <DEVICE-NAME>
The following keywords are recursive and common to all of the above parameters:
•
on <DEVICE-NAME> – Optional. Displays overall OSPF information, based on the parameters passed,
on a specified device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.