Dhcp-pool-mode commands – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 948

Advertising
background image

Brocade Mobility RFS Controller CLI Reference Guide

937

53-1003098-01

13

excluded-address Prevent DHCP Server from assigning certain addresses

lease Address lease time

netbios-name-server NetBIOS (WINS) name servers

netbios-node-type NetBIOS node type

network Network on which DHCP server will be deployed

next-server Next server in boot process

no Negate a command or set its defaults

option Raw DHCP options

respond-via-unicast Send DHCP offer and DHCP Ack as unicast messages

static-binding Configure static address bindings

static-route Add static routes to be installed on dhcp clients

update Control the usage of DDNS service

clrscr Clears the display screen

commit Commit all changes made in this session

do Run commands from Exec mode

end End current mode and change to EXEC mode

exit End current mode and down to previous mode

help Description of the interactive help system

revert Revert changes

service Service Commands

show Show running system information

write Write running configuration to memory or terminal

rfs7000-37FABE(config-dhcp-policy-test-pool-pool1)#

Related Commands:

dhcp-pool-mode commands

dhcp-pool

Configures the DHCP pool parameters

The following table summarizes DHCP pool configuration commands.

no

Removes a specified DHCP address pool

Command

Description

Reference

address

Specifies a range of addresses for a DHCP address pool

page 938

bootfile

Assigns a bootfile name. The bootfile name can contain letters, numbers, dots and
hyphens. Consecutive dots and hyphens are not permitted.

page 939

ddns

Configures dynamic DNS parameters

page 940

default-router

Configures a default router or gateway IP address for the network pool

page 941

dns-server

Sets a DNS server’s IP address available to all DHCP clients connected to the DHCP
pool

page 942

domain-name

Sets the domain name for the network pool

page 943

excluded-address

Prevents a DHCP server from assigning certain addresses to the DHCP pool

page 944

lease

Sets a valid lease for the IP address used by DHCP clients in the DHCP pool

page 946

netbios-name-server

Configures a NetBIOS (WINS) name server’s IP address

page 947

netbios-node-type

Defines the NetBIOS node type

page 948

network

Configures the network on which the DHCP server is deployed

page 949

Advertising