Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 674)

Brocade Mobility RFS Controller CLI Reference Guide 661
53-1003098-01
7
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#dot1x
authenticator guest-vlan 2
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#dot1x
authenticator host-mode multi-host
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#dot1x
authenticator max-reauth-req 6
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#dot1x
authenticator reauthenticate
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#show
context
interface ge1
dot1x authenticator host-mode multi-host
dot1x authenticator guest-vlan 2
dot1x authenticator reauthenticate
dot1x authenticator max-reauth-count 6
ip dhcp trust
qos trust dscp
qos trust 802.1p
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-ge1)#
Related Commands:
dot1x (supplicant)
interface-config-instance
Configures 802.1X supplicant (client) settings
host-mode
[multi-host|single-host] Configures the host mode for this interface
•
multi-host – Configures multiple host mode
•
single-host – Configures single host mode. This is the default setting.
max-reauth-req <1-10> Configures maximum number of reauthorization retries for the supplicant. This is the maximum number of
reauthentication attempts made before this port is moved to unauthorized.
•
<1-10> – Specify a value from 1 -10. The default is 2.
port-control
[auto|force-authorized|
force-unauthorized] Configures port control state
•
auto – Configures auto port state
•
force-authorized – Configures authorized port state. This is the default setting.
•
force-unauthorized – Configures unauthorized port state
reauthenticate Enables or disables re-authentication for this port. When enabled, clients are forced to reauthenticate on
this port. The setting is disabled by default. Therefore, clients are not required to reauthenticate for
connection over this port until this setting is enabled.
timeout [quiet-period|
reauth-period]
<1-65535> Configures timeout settings for this interface
•
quiet-period – Configures the quiet period timeout in seconds. This is the interval, in seconds, between
successive client authentication attempts.
•
reauth-period – Configures the time after which re-authentication is initiated
The following option is common to ‘quiet-period’ and ‘reauth-period’ keywords:
•
<1-65535> – Specify a ‘quiet-period’ or ‘reauth-period’ from 1 -65535 seconds.
no Disables or reverts interface settings to their default