Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 313)

Brocade Mobility RFS Controller CLI Reference Guide 297
53-1003098-01
4
layout map-location <URL> units [feet|meters] {(area <AREA-NAME>|floor
<FLOOR-NAME>)}
Parameters
layout area <AREA-NAME> {(floor|map-location)}
layout floor <FLOOR-NAME>{(<1-4094>|area|maplocation)}
layout map-location <URL> units [feet|meters] {(area <AREA-NAME>|floor
<FLOOR-NAME>)}
Example
rfs7000-37FABE(config-rf-domain-default)#layout map-location
www.firstfloor.com units meters area Ecospace floor Floor5
rfs7000-37FABE(config-rf-domain-default)#show context
rf-domain default
contact Bob+919621212577
country-code in
channel-list 2.4GHz 1,2,3,4,5,6,7,8,9,10
layout area Ecospace floor Floor5 map-location www.fiestfloor.com units
meters
control-vlan 1
rfs7000-37FABE(config-rf-domain-default)#
Related Commands:
location
rf-domain-mode commands
layout Configures the RF Domain’s layout in terms of area, floor, and location on a map
area <AREA-NAME> Configures the RF Domain’s area name
•
<AREA-NAME> – Specify the area name.
After configuring the RF Domain’s area of functioning, optionally specify the floor name (and number),
and/or the map location.
layout Configures the RF Domain’s layout in terms of area, floor, and location on a map
floor <FLOOR-NAME>
<1-4094> Configures the RF Domain’s floor name
•
<FLOOR-NAME> – Specify the floor name.
•
<1-4094> – Optional. Specifies the floor number from 1 - 4094. The default floor number is 1.
After configuring the RF Domain’s floor name (and number), optionally specify the area name and/or the
map location.
layout Configures the RF Domain’s layout in terms of area, floor, and location on the map
map-location <URL> units
[feet|meters] Configures the location of the RF Domain on the map
•
<URL> – Specify the URL to configure the map location.
NOTE: units [feet|meters] – Configures the map units in terms of feet or meters
area <AREA-NAME> Optional. Configures the RF Domain’s area name. Specify area name.
After configuring the RF Domain’s area name, optionally specify the floor name and number
floor <FLOOR-NAME> Optional. Configures the RF Domain’s floor name. Specify floor name.
After configuring the floor name (and number) for this RF Domain, optionally specify the area name.
no Removes the RF Domain layout details