Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 792)

Brocade Mobility RFS Controller CLI Reference Guide 779
53-1003098-01
7
arp Configures static address resolution protocol
auto-learn-staging-config Enables network configuration device learning
autogen-uniqueid Autogenerates a unique local ID for devices using this profile. When executed in the device
configuration mode, this command generates a unique ID for the logged device.
autoinstall Configures the autoinstall feature
bridge Configures bridge specific commands
captive-portal Configures captive portal advanced Web page uploads on a profile or device
cdp Enables CDP on a device
cluster Configures a cluster name
configuration-persistence Enables configuration persistence across reloads
controller Configures a wireless controller or service platform
critical-resource Monitors user configured IP addresses and logs their status
crypto Configures crypto settings
device-upgrade Configures device firmware upgrade settings on this profile
dot1x Configures 802.1x standard authentication controls
dscp-mapping Configures an IP DSCP to 802.1p priority mapping for untagged frames
email-notification Configures e-mail notification
enforce-version Enables checking of a device’s firmware version before attempting adoption or clustering
environmental-sensor Configures the environmental sensor device settings
events Displays system event messages
export Enables the export of the startup.log file after every boot
floor Sets the floor name where the system is located
gre Enables GRE tunneling on this device
http-analyze Configures HTTP analysis settings
interface Configures an interface
ip Configures IP components
l2tpv3 Defines the Layer 2 Tunnel Protocol (L2TP) protocol for tunneling layer 2 payloads using VPNs
l3e-lite-table Configures L3e Lite Table with this profile
led Turns device LEDs on or off
led-timeout Configures LED-timeout timer. This command is specific to the NX9000 series service platforms.
legacy-auto-downgrade Auto downgrades a legacy device firmware
legacy-auto-update Auto upgrades a legacy device firmware
lldp Configures Link Layer Discovery Protocol (LLDP)
load-balancing Configures load balancing parameters
logging Modifies message logging
mac-address-table Configures the MAC address table
mac-auth Enables 802.1x port-based user authentication on this device
memory-profile Configures the memory profile used on the device