Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 614)

Brocade Mobility RFS Controller CLI Reference Guide 601
53-1003098-01
7
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-policy-testpolicy)#no
dpd-retries
The following example shows the IKEV1 Policy settings after the ‘no’ commands
are executed:
rfs7000-37FABEconfig-profile-default-rfs7000-ikev1-policy-testpolicy)#show
context
crypto ikev1 policy testpolicy
lifetime 655
isakmp-proposal default encryption aes-256 group 2 hash sha
isakmp-proposal testpraposal encryption aes group 2 hash sha
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-policy-testpolicy)#
crypto-ikev1/ikev2-peer commands
crypto
Use the (config) instance to configure IKEv1/IKEv2 peer configuration commands. To navigate to
the IKEv1 peer config instance, use the following commands:
<DEVICE>(config)#profile <DEVICE-TYPE> <PROFILE-NAME>
<DEVICE>(config-profile-<PROFILE-NAME>)#crypto ikev1/ikev2 peer
<IKEV1/IKEV2-PEER-NAME>
rfs7000-37FABE(config-profile-default-rfs7000)#crypto ikev1 peer peer1
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#?
Crypto IKEV1 Peer Configuration commands:
authentication Configure Authentication credentials
ip Configure peer address/fqdn
localid Set local identity
no Negate a command or set its defaults
remoteid Configure remote peer identity
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-ikev1-peer-peer1)#
rfs7000-37FABE(config-profile-default-rfs7000)#crypto ikev2 peer peer1
rfs7000-37FABE(config-profile-default-rfs7000-ikev2-peer-peer1)#?
Crypto IKEV2 Peer Configuration commands:
authentication Configure Authentication credentials
ip Configure peer address/fqdn
localid Set local identity
no Negate a command or set its defaults
remoteid Configure remote peer identity
use Set setting to use
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode