Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1355)

Brocade Mobility RFS Controller CLI Reference Guide 1347
53-1003098-01
A
In the table, the IP address range of 172.16.11.11 to 172.16.11.200 is available using the DHCP
server. To configure the DHCP server:
rfs4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1)#dhcp-pool
DHCP_POOL_USECASE1_01
rfs4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1-pool-DHCP_POOL_USECASE
1_01)#
Configure the address range as follows:
rfs4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1-pool-DHCP_POOL_USECASE
1_01)#address range 172.16.11.11 172.16.11.200
rfs4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1-pool-DHCP_POOL_USECASE
1_01)#
Configure the IP pool used with a network segment. This starts the DHCP server on the specified
interface.
rfs4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1-pool-DHCP_POOL_USECASE
1_01)#network 172.16.11.0/24
rfs4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1-pool-DHCP_POOL_USECASE
1_01)#exit
rfs4000-37FABE(config-dhcp-policy-DHCP_POLICY_UseCase1)#exit
rfs4000-37FABE(config)#commit write
Configure the Brocade Mobility RFS4000 to use the DHCP Policy
For the DHCP to work properly, the new DHCP Server Policy must be applied to the wireless
controller. To apply the DHCP Server Policy to the wireless controller:
rfs4000-37FABE(config)#self
rfs4000-37FABE(config-device-03-14-28-57-14-28)#use dhcp-server-policy
DHCP_POLICY_UseCase1
rfs4000-37FABE(config-device-03-14-28-57-14-28)#commit write
rfs4000-37FABE(config-device-03-14-28-57-14-28)#exit
rfs4000-37FABE(config)#
Completing and Testing the Configuration
Using the Command Line Interface to Configure the WLAN
A wireless client must be configured to associate with the wireless controller managed WLAN. The
following information must be defined:
• SSID: WLAN_USECASE_01
• Country: Same as the country configured in Creating a RF Domain on page A-1341 . In this
scenario, the country code is set to US.
• Mode: Infrastructure
With the WLAN set to beacon, use the wireless client’s discovery client to discover the configured
WLAN and associate.