Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1140)

1132 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
20
Parameters
coverage-hole-recovery {client-threshold [2.4GHz|5GHz] <1-255>}
coverage-hole-recovery {coverage-interval|interval} [2.4GHz|5GHz] <1-120>
coverage-hole-recovery {snr-threshold} [2.4Ghz|5Ghz] <1-75>
Example
rfs7000-37FABE(config-smart-rf-policy-test)#coverage-hole-recovery
snr-threshold 5GHz 1
rfs7000-37FABE(config-smart-rf-policy-test)#show context
smart-rf-policy test
area test channel-list 2.4GHz 1,2,3
sensitivity custom
assignable-power 5GHz min 8
assignable-power 5GHz max 20
channel-list 2.4GHz 1,12
channel-width 5GHz auto
coverage-hole-recovery snr-threshold 5GHz 1
rfs7000-37FABE(config-smart-rf-policy-test)#
client-threshold Optional. Specifies the minimum number of clients associated to a radio in order to trigger coverage
hole recovery.
2.4GHz <1-255> Specifies the minimum number of clients on the 2.4 GHz band
•
<1-255> – Sets a value from 1 - 255. The default is 1.
5GHz <1-255> Specifies the minimum number of clients on the 5.0 GHz band
•
<1-255> – Sets a value from 1 - 255. The default is 1.
coverage-interval Optional. Specifies the interval between the discovery of a coverage hole and the initiation of coverage
hole recovery
interval Optional. Specifies the interval at which coverage hole recovery is performed even before a coverage
hole is detected
2.4GHz <1-120> The following keywords are common to the ‘coverage-interval’ and ‘interval’ parameters:
•
2.4GHz <1-120> – Specifies the coverage hole recovery interval on the 2.4 GHz band
•
<1-120> – Specify a value from 1 - 120 seconds.
NOTE: coverage-interval – The default is 10 seconds.
NOTE: interval – The default is 30 seconds.
5GHz <1-120> The following keywords are common to the ‘coverage-interval’ and ‘interval’ parameters:
•
5GHz <1-120> – Specifies a coverage hole recovery interval on the 5.0 GHz band
•
<1-120> – Specify a value from 1 - 120 seconds.
NOTE: coverage-interval – The default is 10 seconds.
NOTE: interval – The default is 30 seconds.
snr-threshold Optional. Specifies the SNR threshold. This value is the SNR threshold for an associated client as seen
by its associated AP radio. When the SNR threshold is exceeded, the radio increases its transmit power
to increase coverage for the associated client.
2.4GHz <1-75> Specifies SNR threshold on the 2.4 GHz band
•
<1-75> – Sets a value from 1 dB - 75 dB. The default is 20 dB.
5GHz <1-75> Specifies SNR threshold on the 5.0 GHz band
•
<1-75> – Sets a value from 1 - 75. The default is 20 dB.