Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 363)

Brocade Mobility RFS Controller CLI Reference Guide 347
53-1003098-01
4
authentication-type Reset the authentication to use on
this wlan to default (none/Pre-shared
keys)
broadcast-dhcp Configure broadcast DHCP packet
handling
broadcast-ssid Do not advertise the SSID of the WLAN
in beacons
captive-portal-enforcement Configure how captive-portal is
enforced on the wlan
client-access Disallow client access on this wlan
(no data operations)
client-client-communication Disallow switching of frames from one
wireless client to another on this
wlan
client-load-balancing Disable load-balancing of clients on
this wlan
controller-assisted-mobility Disable configure assisted mobility
data-rates Reset data rate configuration to
default
description Reset the description of the wlan
downstream-group-addressed-forwarding Disable downstream group addressed
forwarding of packets
eap-types Allow all EAP types on this wlan
encryption-type Reset the encryption to use on this
wlan to default (none)
enforce-dhcp Drop packets from Wireless Clients
with static IP address
fast-bss-transition Disable support for 802.11r Fast BSS
Transition
http-analyze Enable HTTP URL analysis on the wlan
ip Internet Protocol (IP)
kerberos Configure kerberos authentication
parameters
mac-authentication Configure mac-authentication related
parameters
mac-registration Dynamic MAC registration of user
motorola-extensions Disable support for Motorola-Specific
extensions to 802.11
protected-mgmt-frames Disable support for Protected
Management Frames (IEEE 802.11w)
proxy-arp-mode Configure handling of ARP requests
with proxy-arp is enabled
radio-resource-measurement Disable support for 802.11k Radio
Resource Measurement
radius Configure RADIUS related parameters
relay-agent Configure dhcp relay agent info
shutdown Enable the use of this wlan
ssid Configure ssid
time-based-access Reset time-based-access parameters to
default
use Set setting to use
vlan Map the default vlan (vlan-id 1) to
the wlan
vlan-pool-member Delete a mapped vlan from this wlan
wep128 Reset WEP128 parameters
wep64 Reset WEP64 parameters
wireless-client Configure wireless-client specific
parameters
wpa-wpa2 Modify tkip-ccmp (wpa/wpa2) related
parameters