Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1167)

Brocade Mobility RFS Controller CLI Reference Guide 1159
53-1003098-01
21
Example
rfs7000-37FABE(config-wips-policy-test)#signature test
rfs7000-37FABE(config-test-signature-test)
rfs7000-37FABE(config-test-signature-test)#?
Wips Signature Mode commands:
bssid Bssid mac address
dst-mac Destination mac address
filter-ageout Configure filter ageout
frame-type Configure frame-type to match
interference-event Signature is a smart-rf interference source
mode Enable/Disable signature
no Negate a command or set its defaults
payload Configure a payload
src-mac Source mac address
ssid-match Match based on ssid
threshold-client Configure client threshold limit
threshold-radio Configure radio threshold limit
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-test-signature-test)#
rfs7000-37FABE(config-wips-policy-test)#show context
wips-policy test
event excessive 80211-replay-check-failure threshold-client 10
threshold-radio 99 filter-ageout 9
no event client-anomaly wellenreiter filter-ageout 99
signature test
interference-event
bssid 11-22-33-44-55-66
dst-mac 55-66-77-88-99-00
frame-type reassoc
filter-ageout 8
threshold-client 88
payload 1 pattern brocade offset 1
br-detection-ageout 50
br-detection-wait-time 15
rfs7000-37FABE(config-wips-policy-test)#
Related Commands:
signature mode commands
signature
no Deletes a WIPS policy signature