Time-based-access – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 370
354
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
encryption-type none
authentication-type none
protected-mgmt-frames mandatory
radius vlan-assignment
motorola-extensions wmm-load-information
client-load-balancing probe-req-intvl 5ghz 5
client-load-balancing band-discovery-intvl 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
proxy-arp-mode strict
broadcast-dhcp validate-offer
shutdown on-unadoption
http-analyze controller
rfs7000-37FABE(config-wlan-test)#
time-based-access
Configures time-based client access to the network resources
Administrators can use this feature to assign fixed days and time of WLAN access for wireless
clients
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
time-based-access days [sunday|monday|tuesday|wednesday|thursday|friday|
saturday|all|weekends|weekdays] {start <START-TIME>} [end
<END-TIME>]
Parameters
time-based-access days [sunday|monday|tuesday|wednesday|thursday|friday|
saturday|all|weekends|weekdays] {start <START-TIME>} [end <END-TIME>]
day <option>
Specifies the day or days on which the client can access the WLAN
•
sunday – Allows access on Sundays only
•
monday – Allows access on Mondays only
•
Tuesday – Allows access on Tuesdays only
•
wednesday – Allows access on Wednesdays only
•
thursday – Allows access on Thursdays only
•
friday – Allows access on Fridays only
•
saturday – Allows access on Saturdays only
•
weekends – Allows access on weekends only
•
weekdays – Allows access on weekdays only
•
all – Allows access on all days
start <START-TIME>
Optional. Specifies the access start time in hours and minutes (HH:MM)
end <END-TIME>
Specifies the access end time in hours and minutes (HH:MM)