Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 945)

934 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
13
Related Commands:
no
dhcp-class-mode commands
Removes this DHCP user class policy’s settings
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no [multiple-user-class|option]
no option user-class <VALUE>
Parameters
no multiple-user-class
no option user-class <VALUE>
Example
The following example shows the DHCP class settings before the ‘no’ commands
are executed:
rfs7000-37FABE(config-dhcp-policy-test-class-dhcpclass1)#show context
dhcp-class dhcpclass1
option user-class hex
multiple-user-class
rfs7000-37FABE(config-dhcp-policy-test-class-dhcpclass1)#
rfs7000-37FABE(config-dhcp-policy-test-class-class1)#no multiple-user-class
rfs7000-37FABE(config-dhcp-policy-test-class-dhcpclass1)#no option user-class
hex
The following example shows the DHCP class settings after the ‘no’ commands
are executed:
rfs7000-37FABE(config-dhcp-policy-test-class-dhcpclass1)#show context
dhcp-class dhcpclass1
rfs7000-37FABE(config-dhcp-policy-test-class-dhcpclass1)#
no Disables the multiple user class option for the selected DHCP user class policy
no multiple-user-class Disables multiple user class options on this DHCP user class policy
no option user-class
<VALUE> Removes the DHCP user class option identified by the <VALUE> keyword