Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 522)

508 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
show smart-rf interfering-br {<MAC>|<DEVICE-NAME>|on}
show smart-rf interfering-neighbors {<MAC>|<DEVICE-NAME>|on|threshold
<50-100>}
Example
rfs7000-37FABE(config)#show smart-rf calibration-status
No calibration currently in progress
rfs7000-37FABE(config)#
rfs7000-37FABE(config)#show smart-rf history
-----------------------------------------------------------------------------
----------
TIME EVENT DESCRIPTION
-----------------------------------------------------------------------------
----------
-----------------------------------------------------------------------------
----------
Total number of history entries displayed: 0
rfs7000-37FABE(config)#
<MAC> Optional. Displays radio activity for a specified radio
•
<MAC> – Specify the radio’s MAC address.
all-11an Optional. Displays radio activity of all 11a radios in the configuration
all-11bgn Optional. Displays radio activity of all 11bg radios in the configuration
on <DOMAIN-NAME> Optional. Displays radio activity of all radios within a specified RF Domain
•
<DOMAIN-NAME> – Specify the RF Domain name.
interfering-br Displays interfering access points (requiring potential isolation) information
<MAC> Optional. Displays information of a specified interfering access point
•
<MAC> – Specify the access point’s MAC address.
NOTE: Considers all APs if this parameter is omitted
<DEVICE-NAME> Optional. Displays interfering access point information on a specified device
•
<DEVICE-NAME> – Specify the device name.
NOTE: Considers all APs if this parameter is omitted
on <DOMAIN-NAME> Optional. Displays all interfering access point information within a specified RF Domain
•
<DOMAIN-NAME> – Specify the RF Domain name.
interfering-br Displays interfering neighboring access point information
<MAC> Optional. Displays interfering neighboring access point information
•
<MAC> – Specify the access point’s MAC address.
NOTE: Considers all APs if this parameter is omitted
<DEVICE-NAME> Optional. Displays all interfering neighboring access point information on a specified device
•
<DEVICE-NAME> – Specify the device name.
NOTE: Considers all APs if this parameter is omitted
threshold <50-100> Specifies the maximum attenuation threshold of interfering neighbors. Specify a value from
50 -100.
on <DOMAIN-NAME> Optional. Displays radio activity of all radios within a specified RF Domain
•
<DOMAIN-NAME> – Specify the RF Domain name.