Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 248)

232 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
Related Commands:
dns-whitelist-mode commands
dns-whitelist
The following table summarizes DNS Whitelist configuration mode commands.
permit
dns-whitelist-mode commands
A whitelist is a list of host names and IP addresses permitted access to the network or captive
portal. This command adds a device by its hostname or IP address to the DNS whitelist.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
permit <IP/HOSTNAME> {suffix}
Parameters
permit <IP/HOSTNAME> {suffix}
no Removes an existing DNS Whitelist
Command Description Reference
permit Permits a host, existing on a DNS whitelist, access to the network or captive portal page 232
no Negates a command or reverts to default page 233
clrscr Clears the display screen page 385
commit Commits (saves) changes made in the current session page 386
end Ends and exits the current mode and moves to the PRIV EXEC mode page 234
exit Ends the current mode and moves to the previous mode page 387
help Displays the interactive help system page 387
revert Reverts changes to their last saved configuration page 394
service Invokes service commands to troubleshoot or debug
(config-if)
instance configurations page 394
show Displays running system information page 429
write Writes information to memory or terminal page 425
<IP/HOSTNAME> Adds a device to the DNS whitelist
•
<IP/HOSTNAME> – Specify the devices’ IP address or hostname.
A maximum of 256 entries can be made.
suffix Optional. Matches any hostname including the specified name as suffix