Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 76
58
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
2
no service locator {on <DEVICE-NAME>}
no terminal [length|width]
no virtual-machine assign-usb-ports {on <DEVICE-NAME>}
no wireless client all {filter [wlan <WLAN-NAME>]}
no wireless client all {on <DEVICE-OR-DOMAIN-NAME>} {filter [wlan
<WLAN-NAME>]}
no wireless client mac <MAC> {on <DEVICE-OR-DOMAIN-NAME>}
Usage Guidelines:
The
no
command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
Example
rfs7000-37FABE>no adoption
rfs7000-37FABE>no page
rfs7000-37FABE>no service cli-tables-expand line
no service
Disables LEDs on a specified device or all devices in the WLAN. It also resets the CLI table expand and
MiNT protocol configurations.
locator
{on <DEVICE-NAME>}
Disables LEDs on a specified device
•
on <DEVICE-NAME> – Optional. Specify the name of the AP, wireless controller, or service platform.
If no device name is specified, the system disables LEDs on all devices in the WLAN.
no terminal [length|width]
Resets the width of the terminal window or the number of lines displayed within the terminal window
•
length – Resets the number of lines displayed on the terminal window to its default
•
width – Resets the width of the terminal window to its default
no virtual-machine
assign-usb-ports
Reverts ports assigned for virtual-machines back to Mobility
This command is available only on the Brocade Mobility RFS9510 series service platforms.
on <DEVICE-NAME>
Reverts virtual-machine assigned ports on a specified device
•
on <DEVICE-NAME> – Optional. Specify the name of the AP, wireless controller, or service platform.
no wireless client all
Disassociates all clients on a specified device or domain
filter
[wlan <WLAN-NAME>]
Optional. Specifies additional client selection filter
•
wlan – Filters clients on a specified WLAN
•
<WLAN-NAME> – Specify the WLAN name.
no wireless client all
{on
<DEVICE-OR-DOMAIN-NAME>}
Disassociates all wireless clients on a specified device or domain
•
on <DEVICE-OR-DOMAIN-NAME> – Optional. Specify the name of the AP, wireless controller, service
platform, or RF Domain.
filter
[wlan <WLAN-NAME>]
The following are optional filter parameters:
•
filter – Optional. Specifies additional client selection filter
•
wlan – Filters clients on a specified WLAN
•
<WLAN-NAME> – Specify the WLAN name.
no wireless client
mac <MAC>
Disassociates a single wireless client on a specified device or RF Domain
•
mac <MAC> – Specify the wireless client’s MAC address in the AA-BB-CC-DD-EE-FF format.
on
<DEVICE-OR-DOMAIN-NAME>
Optional. Specifies the name of the AP, wireless controller, service platform, or RF Domain to which the
specified client is associated