Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 488)

474 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
show ip igmp snooping vlan <1-4095> {<IP>} {(on <DEVICE-NAME>)}
show ip interface {<INTERFACE-NAME>|brief} {(on <DEVICE-NAME>)}
show ip nat translations verbose {on <DEVICE-NAME>}
show ip route {<INTERFACE-NAME>|ge <1-4>|me1|port-channel <1-2>|vlan <1-4094>|
pppoe1|wwan1} {(on <DEVICE-NAME>)}
mrouter Displays the IGMP snooping multicast router (mrouter) configuration
vlan <1-4095>
{on <DEVICE-NAME>} Displays the IGMP snooping multicast router configuration for a VLAN
•
<1-4095> – Specify the VLAN ID from 1 - 4095.
•
on <DEVICE-NAME> – Optional. Displays the IGMP snooping mrouter configuration on a
specified device
•
<DEVICE-NAME> – Specify the name of the AP or wireless controller.
ip igmp snooping Displays the IGMP snooping configuration
vlan <1-4095> Displays the VLAN IGMP snooping configuration
•
<1-4095> – Specify the VLAN ID from 1 - 4095.
<IP> Optional. Specifies the multicast group IP address
on <DEVICE-NAME> The following keyword is recursive and common to the ‘ip’ parameter:
•
on <DEVICE-NAME> – Optional. Displays configuration details on a specified device
•
<DEVICE-NAME> – Specify the name of the AP or wireless controller.
ip interface Displays an administrative and operational status of all layer 3 interfaces or a specified layer 3 interface
<INTERFACE-NAME> Displays a specified interface status. Specify the interface name.
brief Displays a brief summary of all interface status and configuration
on <DEVICE-NAME> The following keyword is recursive and common to the ‘interface-name’ and ‘brief’ parameters:
•
on <DEVICE-NAME> – Optional. Displays interface status and summary, based on the parameters
passed, on a specified device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
ip nat translations Displays Network Address Translation (NAT) translations
verbose Displays detailed NAT translations
•
on <DEVICE-NAME> – Optional.Displays NAT translations on a specified device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
ip route Displays route table details. The route tables use flags to distinguish between routes. The different flags
are:
•
C – Connected
•
G – Gateway
•
O – OSPF route
•
S – Static route
NOTE: Flags ‘S’ and ‘O’ identify static learned routes and dynamic learned routes respectively.
<INTERFACE-NAME> Displays route table details for a specified interface. Specify the interface name
ge <1-4> Displays GigabitEthernet interface route table details
•
<1-4> – Specify the GigabitEthernet interface index from 1 - 4.
me1 Displays FastEthernet interface route table details
port-channel <1-2> Displays port channel interface route table details. Specify the port channel index from 1 - 2.
vlan <1-4095> Displays VLAN interface route table details. Select the VLAN interface ID from 1 - 4094.