Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 698)

Brocade Mobility RFS Controller CLI Reference Guide 685
53-1003098-01
7
The access point radio interface can be radio1, radio2 or radio3. Legacy Brocade Mobility 71XX
Access Point models contain either a single or a dual radio configuration. Newer Brocade Mobility
71XX Access PointN model access points support single, dual or triple radio configurations. An
Brocade Mobility 650 Access Point model access point is available in either single or dual radio
models. The remainder of the access point portfolio are dual-radio models.
To enter the AP profile > radio interface context, use the following commands:
<DEVICE>(config)#profile <AP-TYPE> <PROFILE-NAME>
rfs7000-37FABE(config)#profile br71xx 71xxTestProfile
rfs7000-37FABE(config-profile-71xxTestProfile)#
rfs7000-37FABE(config-profile-71xxTestProfile)#interface radio 1
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#?
Radio Mode commands:
aeroscout Aeroscout Multicast MAC/Enable
aggregation Configure 802.11n aggregation related parameters
airtime-fairness Enable fair access to medium for clients based on
their usage of airtime
antenna-diversity Transmit antenna diversity for non-11n transmit
rates
antenna-downtilt Enable ADEPT antenna mode
antenna-gain Specifies the antenna gain of this radio
antenna-mode Configure the antenna mode (number of transmit and
receive antennas) on the radio
beacon Configure beacon parameters
channel Configure the channel of operation for this radio
data-rates Specify the 802.11 rates to be supported on this
radio
description Configure a description for this radio
dfs-rehome Revert to configured home channel once dfs
evacuation period expires
dynamic-chain-selection Automatic antenna-mode selection (single antenna
for non-11n transmit rates)
ekahau Ekahau Multicast MAC/Enable
extended-range Configure extended range
guard-interval Configure the 802.11n guard interval
ldpc Configure support for Low Density Parity Check
Code
lock-rf-mode Retain user configured rf-mode setting for this
radio
max-clients Maximum number of wireless clients allowed to
associate subject to AP limit
mesh Configure radio mesh parameters
meshpoint Enable meshpoints on this radio
no Negate a command or set its defaults
non-unicast Configure handling of non-unicast frames
off-channel-scan Enable off-channel scanning on the radio
placement Configure the location where this radio is
operating
power Configure the transmit power of the radio
preamble-short Use short preambles on this radio
probe-response Configure transmission parameters for Probe
Response frames
radio-resource-measurement Configure support for 802.11k Radio Resource
Measurement