Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1253)

Brocade Mobility RFS Controller CLI Reference Guide 1245
53-1003098-01
25
.b Perform normal destination-based route lookup. If a next hop is found, it is
used, if not refer to (c).
.c If default next hop is configured and reachable, it is used, if not, packet is
dropped.
• Fallback - Enables fallback to destination-based routing if none of the configured next hops are
reachable (or not configured). This is enabled by default.
• Mark IP DSCP - Configures IP DSCP bits for QoS using an ACL. The mark action of the route
maps takes precedence over the mark action of an ACL.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
route-map <1-100>
Parameters
route-map <1-100>
Example
rfs7000-37FABE(config-routing-policy-testpolicy)#route-map 1
rfs7000-37FABE(config-routing-policy-testpolicy)#show context
routing-policy testpolicy
logging
route-map 1
rfs7000-37FABE(config-routing-policy-testpolicy)#
rfs7000-37FABE(config-routing-policy-testpolicy)#route-map 1
rfs7000-37FABE(config-routing-policy-testpolicy-route-map-1)#?
Route Map Mode commands:
default-next-hop Default next-hop configuration (aka
gateway-of-last-resort)
fallback Fallback to destination based routing if no next-hop is
configured or all are unreachable
mark Mark action for route map
match Match clause configuration for Route Map
next-hop Next-hop configuration
no Negate a command or set its defaults
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
route-map <1-100> Creates a route map entry and enters the route map configuration mode. Specify a precedence value
from 1-100.
NOTE: Lower the sequence number, higher is the precedence.