Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 726)

Brocade Mobility RFS Controller CLI Reference Guide 713
53-1003098-01
7
non-unicast
interface-config-radio-instance
Configures the support for non unicast frames on this radio. Enables the forwarding of multicast
and broadcast frames by this radio.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
non-unicast [forwarding|queue|tx-rate]
non-unicast forwarding [follow-dtim|power-save-aware]
non-unicast queue [<1-200>|bss]
non-unicast queue [<1-200>|bss <1-16> <1-200>]
non-unicast tx-rate [bss
<1-16>|dynamic-all|dynamic-basic|highest-basic|lowest-basic]
non-unicast tx-rate bss <1-16> [dynamic-all|dynamic-basic|highest-basic|
lowest-basic]
Parameters
non-unicast forwarding [follow-dtim|power-save-aware]
non-unicast queue [<1-200>|bss <1-16> <1-200>]
non-unicast tx-rate [bss
<1-16>|dynamic-all|dynamic-basic|highest-basic|lowest-basic]
non-unicast Configures support for non unicast frames
forwarding Configures multicast and broadcast frame forwarding on this radio
follow-dtim Specifies frames always wait for the DTIM interval to time out. The DTIM interval is configured using the
beacon command. This is the default setting.
power-save-aware Enables immediate forwarding of frames if all associated wireless clients are in the power save mode
non-unicast Configures support for non unicast frames
queue Configures the number of broadcast packets queued per BSS on this radio. This command also enables
you to override the default on a specific BSS.
<1-200> Specify a number from 1 - 200.
bss <1-16> <1-200> Overrides the default on a specified BSS
•
<1-16> – Select the BSS to override the default.
•
<1-200> – Specify the number of broadcast packets queued for the selected BSS.
non-unicast Configures support for non unicast frames
tx-rate Configures the transmission data rate for broadcast and multicast frames
bss <1-16> Overrides the default on a specified BSS
•
<1-16> – Select the BSS to override the default.
dynamic-all Dynamically selects a rate from all supported rates based on current traffic conditions
dynamic-basic Dynamically selects a rate from all supported basic rates based on current traffic conditions