Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1352)

1344 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
A
rfs4000(config-profile-AP650_UseCase1)#interface vlan 2
rfs4000(config-profile-AP650_UseCase1-if-vlan2)#
Configure this VLAN to use DHCP, so any device that is associated using this access point is
automatically assigned a unique IP address. Once completed, exit this context.
rfs4000(config-profile-Brocade Mobility 650 Access Point_UseCase1-if-vlan2)#ip
address dhcp
rfs4000(config-profile-Brocade Mobility 650 Access
Point_UseCase1-if-vlan2)#exit
The VLAN has to be mapped to a physical interface on the access point. Since the only available
physical interface on the Brocade Mobility 650 Access Point is GE1, this VLAN is mapped to it.
rfs4000(config-profile-Brocade Mobility 650 Access Point_UseCase1)#interface
ge 1
rfs4000(config-profile-Brocade Mobility 650 Access
Point_UseCase1-if-ge1)#switchport access vlan 2
rfs4000(config-profile-Brocade Mobility 650 Access Point_UseCase1-if-ge1)#exit
Before a WLAN can be implemented, it has to be mapped to a radio on the access point. An
Brocade Mobility 650 Access Point has 2 radios, in this scenario, both radios are utilized.
rfs4000(config-profile-Brocade Mobility 650 Access Point_UseCase1)#interface
radio 1
rfs4000(config-profile-Brocade Mobility 650 Access
Point_UseCase1-if-radio1)#wlan 1
rfs4000(config-profile-Brocade Mobility 650 Access
Point_UseCase1-if-radio1)#exit
rfs4000(config-profile-Brocade Mobility 650 Access Point_UseCase1)#interface
radio 2
rfs4000(config-profile-Brocade Mobility 650 Access
Point_UseCase1-if-radio2)#wlan 1
rfs4000(config-profile-Brocade Mobility 650 Access
Point_UseCase1-if-radio2)#exit
rfs4000(config-profile-Brocade Mobility 650 Access Point_UseCase1)#
Commit the changes made to this profile and exit.
rfs4000(config-profile-Brocade Mobility 650 Access Point_UseCase1)#commit
write
rfs4000(config-profile-Brocade Mobility 650 Access Point_UseCase1)#exit
rfs4000(config)#
Apply this Profile to the Discovered Brocade Mobility 650 Access Point
Access the discovered access point using the following command. The discovered device’s MAC
address is used to access its context.
rfs4000(config)#br650 00-A0-F8-00-00-01
rfs4000(config-device-00-A0-F8-00-00-01)#
Assign the AP profile to this Brocade Mobility 650 Access Point access point.
rfs4000(config-device-00-A0-F8-00-00-01)#use profile AP650_UseCase1
rfs4000(config-device-00-A0-F8-00-00-01)#commit write
Apply the RF Domain profile to the AP
Apply the previously created RF Domain to enable a country code to be assigned to the discovered
access point. A discovered access point only works properly if its country code is the country code
of its associated wireless controller.