Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 193)

Brocade Mobility RFS Controller CLI Reference Guide 177
53-1003098-01
4
Captive portals use a Web provisioning tool to create guest user accounts directly on the controller,
service platform, or access point. The connection medium defined for the Web connection is either
HTTP or HTTPS. Both HTTP and HTTPS use a request and response procedure to disseminate
information to and from requesting wireless clients.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
captive-portal <CAPTIVE-PORTAL-NAME>
Parameters
captive-portal <CAPTIVE-PORTAL-NAME>
Example
rfs7000-37FABE(config)#captive-portal test
rfs7000-37FABE(config-captive-portal-test)#?
Captive Portal Mode commands:
access-time Allowed access time for the client. Used when
there is no session time in radius response
access-type Access type of this captive portal
accounting Configure how accounting records are created for
this captive portal policy
bypass Bypass captive portal
connection-mode Connection mode for this captive portal
custom-auth Custom user information
data-limit Enforce data limit for clients
inactivity-timeout Inactivity timeout in seconds. If a frame is not
received from client for this amount of time, then
current session will be removed
logout-fqdn Configure the FQDN address to logout the session
from client
no Negate a command or set its defaults
post-authentication-vlan Configure post authentication vlan for captive
portal users
radius-vlan-assignment Enable radius vlan assignment for captive portal
users
redirection Configure connection redirection parameters
server Configure captive portal server parameters
simultaneous-users Particular username can only be used by a certain
number of MAC addresses at a time
terms-agreement User needs to agree for terms and conditions
use Set setting to use
webpage Configure captive portal webpage parameters
webpage-auto-upload Enable automatic upload of advanced webpages
webpage-location The location of the webpages to be used for
authentication. These pages can either be hosted
on the system or on an external web server.
<CAPTIVE-PORTAL-NAME> Specify the captive portal name. If the captive portal does not exist, it is created.