Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 369)

Brocade Mobility RFS Controller CLI Reference Guide 353
53-1003098-01
4
If the shutdown on-meshpoint-loss feature is enabled, the WLAN status changes only if the
meshpoint and the WLAN are mapped to the same VLAN. If the meshpoint is mapped to VLAN 1
and the WLAN is mapped to VLAN 2, then the WLAN status does not change on loss of the
meshpoint.
Example
rfs7000-37FABE(config-wlan-test)#shutdown on-unadoption
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid test
bridging-mode local
encryption-type none
authentication-type none
protected-mgmt-frames mandatory
radius vlan-assignment
motorola-extensions wmm-load-information
client-load-balancing probe-req-intvl 5ghz 5
client-load-balancing band-discovery-intvl 2
acl exceed-rate wireless-client-denied-traffic 20 disassociate
proxy-arp-mode strict
broadcast-dhcp validate-offer
shutdown on-unadoption
http-analyze controller
rfs7000-37FABE(config-wlan-test)#
ssid
wlan-mode commands
Configures a WLAN’s SSID
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
ssid <SSID>
Parameters
ssid <SSID>
Example
rfs7000-37FABE(config-wlan-test)#ssid testWLAN1
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid testWLAN1
bridging-mode local
<SSID> Specify the WLAN’s SSID. The WLAN SSID is case sensitive and alphanumeric. Its length should not exceed
32 characters.