Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1218)

1210 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
23
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
router-id [<1-4294967295>|<IP>]
Parameters
router-id [<1-4294967295>|<IP>]
Example
rfs7000-37FABE(config-profile
default-rfs7000-l2tpv3-tunnel-Tunnel1)#router-id 2000
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#show
context
l2tpv3 tunnel Tunnel1
peer 2 hostname tunnel1peer1 udp port 100
router-id 2000
establishment-criteria cluster-master
rfs7000-37FABE(config-profile default-rfs7000-l2tpv3-tunnel-Tunnel1)#
Related Commands:
session
l2tpv3-tunnel-commands
Configures a session’s pseudowire ID, which describes the session’s purpose. The session
established message sends this pseudowire ID to the L2TPv3 peer.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
session <L2TPV3-SESSION-NAME> pseudowire-id <1-4294967295> traffic-source
vlan <VLAN-ID-RANGE> {native-vlan <1-4094>}
Parameters
router-id
[<1-4294967295>|<IP>] Configures the tunnel’s local router ID in one of the following formats:
•
<1-4294967295> – Router ID in the number format (from1- 4294967295)
•
<IP> – Router ID in IP address format (A.B.C.D)
no Removes the tunnel’s router ID