Mesh – Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 721
708
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
beacon dtim-period bss 14 5
beacon dtim-period bss 15 5
beacon dtim-period bss 16 5
antenna-gain 12.0
guard-interval long
aggregation ampdu tx-only
aeroscout forward
ekahau forward ip 172.16.10.1 port 3
antenna-mode 2x2
antenna-diversity
max-clients 100
airtime-fairness prefer-ht weight 6
lock-rf-mode
extended-range 15
antenna-downtilt
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
mesh
interface-config-radio-instance
Use this command to configure radio mesh parameters. A Wireless Mesh Network (WMN) is a
network of radio nodes organized in a mesh topology. It consists of mesh clients, mesh routers, and
gateways.
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
mesh [client|links|portal|preferred-peer|psk]
mesh [client|links <1-6>|portal|preferred-peer <1-6> <MAC>|psk [0 <LINE>|2
<LINE>|
<LINE>]]
Parameters
mesh [client|links <1-6>|portal|preferred-peer <1-6> <MAC>|psk [0 <LINE>|2
<LINE>|
<LINE>]]
Resets the maximum number of wireless clients allowed to associate with a radio
mesh
Configures radio mesh parameters, such as maximum number of mesh links, preferred peer device, client
operations etc.
client
Enables operation as a client (scans for mesh portals or nodes that have connectivity to portals and
connects through them)
Setting the mesh mode to ‘client’ enables the radio to operate as a mesh client that scans for and connects
to mesh portals or nodes that are connected to portals.
links <1-6>
Configures the maximum number of mesh links a radio attempts to create
•
<1-6> – Sets the maximum number of mesh links from 1 - 6. The default is 3.