Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 346)

330 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
client-load-balancing {allow-single-band-clients [2.4Ghz|5Ghz]|
band-discovery-intvl <0-10000>|capability-ageout-time <0-10000>}
client-load-balancing {max-probe-req|probe-req-intvl} [2.4Ghz|5Ghz] <0-10000>
Parameters
client-load-balancing {allow-single-band-clients [2.4Ghz|5Ghz]|
band-discovery-intvl <0-10000>|capability-ageout-time <0-10000>}
client-load-balancing {max-probe-req|probe-req-intvl} [2.4Ghz|5Ghz] <0-10000>
Example
rfs7000-37FABE(config-wlan-test)#client-load-balancing band-discovery-intvl 2
rfs7000-37FABE(config-wlan-test)#client-load-balancing probe-req-intvl 5ghz 5
rfs7000-37FABE(config-wlan-test)#show context
wlan test
ssid test
bridging-mode local
encryption-type none
authentication-type eap
accounting syslog host 172.16.10.4 port 2
client-load-balancing probe-req-intvl 5ghz 5
client-load-balancing band-discovery-intvl 2
captive-portal-enforcement fall-back
acl exceed-rate wireless-client-denied-traffic 20 disassociate
broadcast-dhcp validate-offer
rfs7000-37FABE(config-wlan-test)#
controller-assisted-mobility
wlan-mode commands
Enables controller or service platform assisted mobility to determine a wireless client’s VLAN
assignment
client-load-balancing Configures client load balancing on a WLAN
allow-single-band-clients
[2.4GHz|5GHz] Optional. Allows single band clients to associate even during load balancing
•
2.4GHz – Enables load balancing across 2.4 GHz channels
•
5GHz – Enables load balancing across 5.0 GHz channels
band-discovery-intvl
<0-10000> Optional. Configures the interval to discover a client's band capability before connection
•
<0-10000> – Specify a value from 0 - 10000 seconds.
capability-ageout-time
<0-10000> Optional. Configures a client's capability ageout interval
•
<0-10000> – Specify a value from 0 - 10000 seconds.
client-load-balancing Configures WLAN client load balancing
max-probe-req
[2.4GHz|5GHz]
<0-10000> Optional. Configures client probe request interval limits for device association
•
2.4GHz – Configures maximum client probe requests on 2.4 GHz radios
•
5GHz – Configures maximum client probe requests on 5.0 GHz radios
•
<0-10000> – Specify a client probe request threshold from 0 - 100000.
probe-req-intvl
2.4GHz|5GHz]
<0-10000> Optional. Configures client probe request interval limits for device association
•
2.4GHz – Configures the client probe request interval on 2.4 GHz radios
•
5GHz – Configures the client probe request interval on 5.0 GHz radios
•
<0-10000> – Specify a value from 0 - 100000.