Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 658
Brocade Mobility RFS Controller CLI Reference Guide
645
53-1003098-01
7
gre tunnel <GRE-TUNNEL-NAME>
Example
rfs4000-229D58(config-profile testBrocade Mobility
RFS4000-gre-tunnel-testGREtunnel)#?
GRE Tunnel Mode commands:
dscp Differentiated Services Code Point
failover Gre tunnel failover
native Native trunking characteristics
no Negate a command or set its defaults
peer GRE peer
tunneled-vlan VLANs to tunnel
clrscr Clears the display screen
commit Commit all changes made in this session
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs4000-229D58(config-profile testBrocade Mobility
RFS4000-gre-tunnel-testGREtunnel)#
rfs4000-229D58(config-profile testBrocade Mobility
RFS4000-gre-tunnel-testGREtunnel)#peer 1 ip 192.168.13.8
rfs4000-229D58(config-profile testBrocade Mobility
RFS4000-gre-tunnel-testGREtunnel)#peer 2 ip 192.168.13.10
rfs4000-229D58(config-profile testBrocade Mobility
RFS4000-gre-tunnel-testGREtunnel)#show context
gre tunnel testGREtunnel
peer 1 ip 192.168.13.8
peer 2 ip 192.168.13.10
rfs4000-229D58(config-profile testBrocade Mobility
RFS4000-gre-tunnel-testGREtunnel)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000)#show context
profile rfs4000 testBrocade Mobility RFS4000
bridge vlan 1
tunnel-over-level2
ip igmp snooping
ip igmp snooping querier
.............................................................................
.....
use firewall-policy default
service pm sys-restart
router ospf
gre tunnel testGREtunnel
peer 1 ip 192.168.13.8
peer 2 ip 192.168.13.10
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000)#
gre tunnel
<GRE-TUNNEL-NAME>
Creates a new GRE tunnel or modifies an existing GRE tunnel
•
<GRE-TUNNEL-NAME> – If creating a new tunnel, specify a unique name for it. If modifying an
existing tunnel, specify its name.