Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 315)

Brocade Mobility RFS Controller CLI Reference Guide 299
53-1003098-01
4
Syntax:
mac-name <MAC> <NAME>
Parameters
mac-name <MAC> <NAME>
Example
rfs7000-37FABE(config-rf-domain-default)#mac-name 11-22-33-44-55-66
TestDevice
rfs7000-37FABE(config-rf-domain-default)#show context
rf-domain default
location SanJose
contact Bob+919621212577
country-code in
channel-list 2.4GHz 1,2,3,4,5,6,7,8,9,10
mac-name 11-22-33-44-55-66 TestDevice
layout area Ecospace floor Floor5 map-location www.fiestfloor.com units
meters
control-vlan 1
rfs7000-37FABE(config-rf-domain-default)#
Related Commands:
no
rf-domain-mode commands
Negates a command or reverts configured settings to their default. When used in the config RF
Domain mode, the
no
command negates or reverts RF Domain settings.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
no
[alias|channel-list|contact|control-vlan|controller-managed|country-code|layo
ut|
location|mac-name|override-smartrf|override-wlan|sensor-server|stats|timezone
|
tree-node|use]
mac-name Configures a relevant name for each MAC address
<MAC> <NAME> Specifies the MAC address
•
<NAME> – Specify a friendly name for this MAC address to use in events and statistics.
no Removes the MAC address to name mapping