Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 424
Brocade Mobility RFS Controller CLI Reference Guide
409
53-1003098-01
5
service smart-rf [clear-history|interactive-calibration|run-calibration|
save-config|stop-calibration] {on <DOMAIN-NAME>}
service smart-rf interactive-calibration-result
[discard|replace-current-config|
write-to-configuration] {on <DOMAIN-NAME>}
service ssm dump-core-snapshot
service ssm trace pattern <WORD> {on <DEVICE-NAME>}
service wireless client beacon-request <MAC> mode [active|passive|table]
ssid [<SSID>|any] channel-report [<CHANNEL-LIST>|none] {on <DEVICE-NAME>}
<MAC>
Optional. Clears WLAN Smart RF configuration on a device identified by its MAC address. Specify the
device’s MAC address in the AA-BB-CC-DD-EE-FF format.
<DEVICE-NAME>
Optional. Clears WLAN Smart RF configuration on a device identified by its hostname. Specify the device’s
hostname.
on <DOMAIN-NAME>
Optional. Clears WLAN Smart RF configuration on all devices in a specified RF Domain
•
<DOMAIN-NAME> – Specify the RF Domain name.
smart-rf
Enables Smart RF management
clear-history
Clears WLAN Smart RF history on all devices
interactive-calibration
Enables an interactive Smart RF calibration
run-calibration
Starts a new Smart RF calibration process
save-config
Saves the Smart RF configuration on all devices, and also saves the history on the RF Domain Manager
stop-calibration
Stops an in-progress Smart RF calibration
on <DOMAIN-NAME>
Optional. Clears WLAN Smart RF configuration on all devices in a specified RF Domain
•
<DOMAIN-NAME> – Specify the RF Domain name.
smart-rf
Enables Smart RF management
interactive-calibration-result Displays interactive Smart RF calibration results
discard
Discards interactive Smart RF calibration results
replace-current-config
Replaces current radio configuration
write-to-configuration
Writes and saves radio settings to configuration
on <DOMAIN-NAME>
Optional. Displays interactive Smart RF calibration results on a specified RF Domain
•
<DOMAIN-NAME> – Specify the RF Domain name.
ssm
dump-core-snapshot
Triggers a debug core dump of the SSM module
ssm trace
Displays the SSM module trace based on parameters passed
pattern <WORD>
Configures the pattern to match
•
<WORD> – Specify the pattern to match.
on <DEVICE-NAME>
Optional. Displays the SSM module trace on a specified device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
wireless client
beacon-requests
Sends beacon measurement requests to a wireless client
<MAC>
Specify the wireless client’s MAC address.