Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 35)

Brocade Mobility RFS Controller CLI Reference Guide 17
53-1003098-01
2
captive-portal-page-upload
User Exec Commands
Uploads captive portal advanced pages
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
captive-portal-page-upload [<CAPTIVE-PORTAL-NAME>|cancel-upload|load-file]
captive-portal-page-upload <CAPTIVE-PORTAL-NAME>
[<MAC/HOSTNAME>|all|rf-domain]
captive-portal-page-upload <CAPTIVE-PORTAL-NAME> [<MAC/HOSTNAME>|all]
{upload-time <TIME>}
captive-portal-page-upload <CAPTIVE-PORTAL-NAME> rf-domain
[<DOMAIN-NAME>|all]
{from-controller} {(upload-time <TIME>)}
captive-portal-page-upload cancel-upload [<MAC/HOSTNAME>|all|on rf-domain
[<DOMAIN-
NAME>|all]]
captive-portal-page-upload load-file <CAPTIVE-PORTAL-NAME> <URL>
Parameters
captive-portal-page-upload <CAPTIVE-PORTAL-NAME> [<MAC/HOSTNAME>|all]
{upload-time <TIME>}
service Invokes service commands to troubleshoot or debug (config-if) instance
configurations
page 394
show Displays running system information page 429
write Writes information to memory or terminal page 425
exit Ends the current CLI session and closes the session window page 65
TABLE 1 User Exec Mode Commands (Continued)
Command Description Reference
captive-portal-page-upload
<CAPTIVE-PORTAL-NAME> Uploads advanced pages of the captive-portal identified by the <CAPTIVE-PORTAL-NAME> parameter
•
<CAPTIVE-PORTAL-NAME> – Specify the captive portal’s name (should be existing and configured).
<MAC/HOSTNAME> Uploads to a specified AP
•
<MAC/HOSTNAME> – Specify AP’s MAC address or hostname.
all Uploads to all APs
upload-time <TIME> Optional. Configures an AP upload time
•
<TIME> – Specify upload time in the MM/DD/YYYY-HH:MM or HH:MM format.