Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 753)

740 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
use ip-access-list in <ACCESS-LIST-NAME>
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#use
ip-access-list in test
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#show
context
interface wwan1
password TechPubsTesting123
crypto map test
ip nat inside
use ip-access-list in test
ip default-gateway priority 1
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#
Related Commands:
username
interface-config-wwan-instance
Configures the names of users accessing this interface
Supported in the following platforms:
• Access Points — Brocade Mobility 7131 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000
Syntax:
username <WORD>
Parameters
username <WORD>
Example
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#username
TechPubsUser1
rfs4000-229D58(config-profile-testBrocade Mobility RFS4000-if-wwan1)#show
context
interface wwan1
username TechPubsUser1
password TechPubsTesting123
crypto map test
ip nat inside
use ip-access-list in test
ip default-gateway priority 1
use ip-access-list in
<ACCESS-LIST-NAME> Associates an IP ACL with this interface
•
<ACCESS-LIST-NAME> – Specify the IP ACL name.
no Removes the IP ACL associated with this interface
username <WORD> Configures the username for authentication support by the cellular data carrier
•
<WORD> – Specify the username (should not exceed 32 characters).