Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 356)

340 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
4
http-analyze syslog host <IP/HOSTNAME> {port <1-65535>} {proxy-mode [none|
through-controller|through-rf-domain-manager]}
Example
rfs4000-229D58(config-wlan-test)#http-analyze syslog host 192.168.13.10 port
21
proxy-mode through-controller
rfs4000-229D58(config-wlan-test)#show context
wlan test
ssid test
bridging-mode tunnel
encryption-type none
authentication-type none
http-analyze syslog host 192.168.13.10 port 21 proxy-mode through-controller
rfs4000-229D58(config-wlan-test)#
ip
wlan-mode commands
Configures Internet Protocol (IP) settings
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
ip [arp|dhcp]
ip arp [header-mismatch-validation|trust]
ip dhcp trust
Parameters
ip arp [header-mismatch-validation|trust]
syslog
host <IP/HOSTNAME> Forwards client and URL information to a syslog server
•
host <IP/HOSTNAME> – Specify the syslog server’s IP address or hostname
port <1-65535> Optional. Specifies the UDP port to connect to the syslog server from 1 - 65535
proxy-mode
[none|
through-controller|
through-rf-domain-manag
er] Optional. Specifies if the request is to be proxied through another device
•
none – Requests are sent directly to syslog server from device
•
through-controller – Proxies requests, to the syslog server, through the controller configuring the device
•
through-rf-domain-manager – Proxies requests, to the syslog server, through the local RF Domain
manager
ip arp Configures the IP settings for ARP packets
header-mismatch-validati
on Verifies mismatch of source MAC address in the ARP and Ethernet headers
trust Sets ARP responses as trusted for a WLAN/range