Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 508)

494 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
6
Parameters
show pppoe-client [configuration|status] {on <DEVICE-NAME>}
Example
rfs7000-37FABE(config)#show pppoe-client configuration
PPPoE Client Configuration:
+-------------------------------------------
| Mode : Disabled
| Service Name :
| Auth Type : pap
| Username :
| Password :
| Idle Time : 600
| Keepalive : Disabled
| Local n/w : vlan1
| Static IP : 0.0.0.0
| MTU : 1492
+-------------------------------------------
rfs7000-37FABE(config)#
privilege
show commands
Displays a device’s existing privilege level
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
show privilege
Parameters
None
Example
rfs7000-37FABE(config)#show privilege
Current user privilege: superuser
pppoe-client Displays PPPoE client information (configuration and status)
configuration Displays detailed PPPoE client configuration
status Displays detailed PPPoE client status
on <DEVICE-NAME> The following keywords are common to ‘configuration’ and ‘status’ parameters:
•
on <DEVICE-NAME> – Optional. Displays detailed PPPoE client status or configuration on a specified
device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.