Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 798)

Brocade Mobility RFS Controller CLI Reference Guide 785
53-1003098-01
7
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
preferred-controller-group <WORD>
Parameters
preferred-controller-group <WORD>
Example
rfs7000-37FABE(config-profile-default-rfs7000)#preferred-controller-group
testGroup
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
mint link ip 1.2.3.4
mint level 1 area-id 88
bridge vlan 1
bridging-mode isolated-tunnel
ip igmp snooping
ip igmp snooping querier
......................................................
qos trust 802.1p
interface pppoe1
use firewall-policy default
ntp server 172.16.10.10 prefer version 1
preferred-controller-group testGroup
misconfiguration-recovery-time 65
noc update-interval 25
service pm sys-restart
router ospf
rfs7000-37FABE(config-profile-default-rfs7000)#
Related Commands:
preferred-tunnel-controller
Profile Config Commands
Configures the tunnel controller's name preferred for tunneling extended VLAN traffic. Devices
using this profile will prefer to route their extended VLAN traffic through the specified tunnel
controller (wireless controller or service platform).
Supported in the following platforms:
<WORD> Specify the name of the controller (wireless controller or service platform) group preferred for adoption.
Devices using this profile are added, on adoption, to the controller group specified here.
no Removes the preferred controller group configuration