Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 689
676
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-if-vlan8)#
The following table summarizes interface VLAN configuration commands.
crypto
interface-config-vlan-instance
Sets encryption module for this VLAN interface. The encryption module (crypto map) is configured
using the crypto map command. For more information, see
Supported in the following platforms:
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
•
Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
•
Service Platforms — Brocade Mobility RFS9510
Syntax:
crypto map <CRYPTO-MAP-NAME>
Parameters
Commands
Description
Reference
Defines the encryption module
Defines the VLAN interface description
Allows an onboard DHCP server to respond to relayed DHCP packets on this interface
Configures Internet Protocol (IP) config commands
Negates a command or sets its default
Shuts down an interface
Defines the settings used with this command
Clears the display screen
Commits (saves) changes made in the current session
Ends and exits the current mode and moves to the PRIV EXEC mode
Ends the current mode and moves to the previous mode
Displays the interactive help system
Reverts changes to their last saved configuration
Invokes service commands to troubleshoot or debug (config-if) instance configurations
Displays running system information
Writes information to memory or terminal