Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1043)

1034 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
16
ssh {login-grace-time <60-300>|port <1-65535>}
Example
rfs7000-37FABE(config-management-policy-test)#ssh port 162
rfs7000-37FABE(config-management-policy-test)#show context
management-policy test
no http server
https server
ftp username superuser password 1
626b4033263d6d2ae4e79c48cdfcccb60fd4c77a8da9e365060597a6d6570ec2 rootdir dir
ssh port 162
snmp-server community snmp1 ro
snmp-server user snmpmanager v3 encrypted des auth md5 0 motorola1123
snmp-server host 172.16.10.23 v3 162
aaa-login radius external
aaa-login radius policy test
idle-session-timeout 0
restrict-access host 172.16.10.2 log all
rfs7000-37FABE(config-management-policy-test)#
Related Commands:
telnet
management-policy
Enables Telnet. Telnet provides a command line interface to a remote host over TCP. Telnet
provides no encryption, but it does provide a measure of authentication. Telnet access is disabled
by default.
By default Telnet, when enabled, uses Transmission Control Protocol (TCP) port 23. Use this
command to change the TCP port.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
telnet {port <1-65535>}
ssh Enables SSH communication between client and server
login-grace-time
<60-300> Optional. Configures the login grace time. This is the interval, in seconds, after which an unsuccessful login
is disconnected.
•
<60-300> – Specify a value from 60 - 300 seconds. The default is 60 seconds.
port <1-65535> Optional. Configures the SSH port. This is the port used for SSH connections.
•
<1-65535> – Specify a value from 1 - 165535. The default port is 22.
no Resets SSH access port to factory default (port 22)