Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 882
870
Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
9
Example
rfs4000-229D58(config-auto-provisioning-policy-test)#upgrade ap621 precedence
1 any
rfs4000-229D58(config-auto-provisioning-policy-test)#upgrade rfs4000
precedence 2 ip 192.168.13.1 192.168.13.5
rfs4000-229D58(config-auto-provisioning-policy-test)#show context
auto-provisioning-policy test
upgrade ap621 precedence 1 any
upgrade rfs4000 precedence 2 ip 192.168.13.1 192.168.13.5
rfs4000-229D58(config-auto-provisioning-policy-test)#
Related Commands:
no
Removes a deny, permit, or redirect rule from the specified auto provisioning policy
Supported in the following platforms:
fqdn <FQDN>
Configures the FQDN to match
FQDN is a domain name that specifies its exact location in the DNS hierarchy. It specifies all domain levels,
including its top-level domain and the root domain.
•
<FQDN> – Specify the FQDN. Devices matching the specified value are upgraded.
ip
[<START-IP>
<END-IP>|<IP/MASK>]
Configures a range of IP addresses and subnet address. Devices having IP addresses within the specified
range or are part of the specified subnet are upgraded.
•
<START-IP> – Specify the first IP address in the range.
•
<END-IP> – Specify the last IP address in the range.
•
<IP/MASK> – Specify the IP subnet and mask to match against the device’s IP address.
lldp-match
<LLDP-STRING>
Configures the device location to match, based on LLDP snoop strings
LLDP is a vendor neutral link layer protocol used to advertise a network device’s identity, capabilities, and
neighbors on a local area network.
•
<LLDP-STRING> – Specify the location. Devices matching the specified string are upgraded.
mac
<START-MAC>
{<END-MAC>}
Configures a single or a range of MAC addresses. Devices matching the specified values are upgraded.
•
<START-MAC> – Specify the first MAC address in the range. Provide only this MAC address to filter a
single device.
•
<END-MAC> – Optional. Specify the last MAC address in the range.
model-number
<MODEL-NUMBER>
Configures the device model number
•
<MODEL-NUMBER> – Specify the model number. Devices matching the specified model number are
upgraded.
serial-number
<SERIAL-NUMBER>
Configures the device’s serial number
•
<SERIAL-NUMBER> – Specify the serial number. Devices matching the specified serial number are
upgraded.
vlan <VLAN-ID>
Configures the VLAN ID
•
<VLAN-ID> – Specify the VLAN ID. Devices assigned to the specified VLAN are upgraded.
Removes an upgrade rule