Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 814)

Brocade Mobility RFS Controller CLI Reference Guide 801
53-1003098-01
7
service enable [l2tpv3|pppoe|radiusd]
service global-association-list blacklist-interval <1-65535>
service meshpoint loop-prevention-port [<L2-INTERFACE-NAME>|ge <1-4>|
port-channel <1-2>]
service pm sys-restart
service power-config [3af-out|force-3at]
service radius dynamic-authorization additional-port <1-65535>
service rss-timeout <0-86400>
service enable l2tpv3 Enables/disables L2TPv3 on this profile
This feature is not supported on Brocade Mobility 650 Access Point, Brocade Mobility 1220 Access Point,
Brocade Mobility 71XX Access Point, Brocade Mobility 1240 Access Point, Brocade Mobility RFS4000,
Brocade Mobility RFS6000, and Brocade Mobility RFS7000.
It is supported only on Brocade Mobility 6511 Access Point.
service enable pppoe Enables PPPoE features. When executed on a device, enables PPPoE on the logged device. When excuted
on a profile, enables PPPoE on all devices using that profile.
service enable radiusd Enables RADIUSD features. When executed on a device, enables RADIUSD on the logged device. When
excuted on a profile, enables RADIUSD on all devices using that profile.
service
global-association-list Configures global association list related parameters
blacklist-interval
<1-65535> Configures the period for which a client is blacklisted. A client is considered blacklisted after being denied
access by the server.
•
<1-65535> – Specify a value from 1 -65535 seconds.
meshpoint
loop-prevention-port Limits meshpoint loop prevention to a single port
<L2-INTERFACE-NAME> Limits meshpoint loop prevention on a specified Ethernet interface
•
<L2-INTERFACE-NAME> – Specify the layer 2 Ethernet interface name.
ge <1-4> Limits meshpoint loop prevention on a specified GigabitEthernet interface
•
ge <1-4> – Specify the GigabitEthernet interface index from 1 - 4.
port-channel <1-2> Limits meshpoint loop prevention on a specified port-channel interface
•
port-channel <1-2> – Specify the port-channel interface index from 1 - 2.
pm sys-restart Enables the process monitor (PM) to restart the system when a process fails
power-config 3af-out Enables LLDP power negotiation, but uses 3af power
power-config force-3at Disables LLDP negotiation and force 802.3at power configuration
radius
dynamic-authorization
additional-port
<1-65535> Configures an additional UDP port used by the device to listen for dynamic authorization messages
•
<1-65535> – Specify a value from 1 - 65535.
The Cisco Identity Services Engine (ISE) server uses port 1700.
rss-timeout
<0-86400> Configures the duration, in seconds, for which an adopted access point will continue to provide wireless
functions even after loosing controller adoption.
•
<0-86400> – Specify a value from 0 - 86400 seconds.