Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 947)

936 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
13
The following table summarizes DHCP pool configuration mode commands.
dhcp-pool
dhcp-pool
Configures a DHCP server address pool
DHCP services are available for specific IP interfaces. A pool (or range) of IP network addresses and
DHCP options can be created for each IP interface defined. This range of addresses is available to
DHCP enabled wireless devices on either a permanent or leased basis. This enables the reuse of
limited IP address resources for deployment in any network. DHCP options are provided to each
DHCP client with a DHCP response and provides DHCP clients information required to access
network resources (default gateway, domain name, DNS server and WINS server configuration). An
option exists to identify the vendor and functionality of a DHCP client. The information is a
variable-length string of characters (or octets) with a meaning specified by the vendor of the DHCP
client.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
dhcp-pool <POOL-NAME>
Parameters
dhcp-pool <POOL-NAME>
Example
rfs7000-37FABE(config-dhcp-policy-test)#dhcp-pool pool1
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1)#?
DHCP pool Mode commands:
address Configure network pool's included addresses
bootfile Boot file name
ddns Dynamic DNS Configuration
default-router Default routers
dns-server DNS Servers
domain-name Configure domain-name
Command Description Reference
dhcp-pool Creates a DHCP pool and enters its configuration mode page 936
dhcp-pool-mode
commands Summarizes DHCP pool configuration mode commands page 937
<POOL-NAME> Creates a DHCP server address pool
•
<POOL-NAME> – Specify a name that appropriately identifies this DHCP address pool. If the
pool does not exist, it is created. The pool name cannot be modified as part of the edit process.
However, an obsolete address pool can be deleted.