Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 22

Advertising

Brocade Mobility RFS Controller CLI Reference Guide

53-1003098-01

rfs7000-37FABE>enable

rfs7000-37FABE#

Most of the USER EXEC mode commands are one-time commands and are not saved across device
reboots. Save the command by executing ‘commit’ command. For example, the show command
displays the current configuration and the clear command clears the interface.

Access the GLOBAL CONFIG mode from the PRIV EXEC mode. In the GLOBAL CONFIG mode, enter
commands that set general system characteristics. Configuration modes, allow you to change the
running configuration. If you save the configuration later, these commands are stored across
device reboots.

Access a variety of protocol specific (or feature-specific) modes from the global configuration mode.
The CLI hierarchy requires you to access specific configuration modes only through the global
configuration mode.

rfs7000-37FABE# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

rfs7000-37FABE(config)#

You can also access sub-modes from the global configuration mode. Configuration sub-modes
define specific features within the context of a configuration mode.

rfs7000-37FABE(config)# aaa-policy test

rfs7000-37FABE(config-aaa-policy-test)#

Table 1

summarizes available CLI commands.

TABLE 1

Controller CLI Modes and Commands

User Exec Mode

Priv Exec Mode

Global Configuration Mode

captive-portal-page-upload